1. 04 Mar, 2008 5 commits
    • dickelbeck's avatar
      Beautification · 1da6b3a4
      dickelbeck authored
      1da6b3a4
    • dickelbeck's avatar
      Beautification, Doxyfile edits · 3d73eb68
      dickelbeck authored
      3d73eb68
    • lifekidyeaa's avatar
      added an option to enable/disable magnetic tracks in the general options... · 0dc3be88
      lifekidyeaa authored
      added an option to enable/disable magnetic tracks in the general options dialog of PCBnew (same as the magnetic 
      pads option.)  Haven't fixed the via issue 
      (since I don't quite understand why it is doing this, nor does it occur in 100% of the cases), but now you can just 
      turn 
      off magnetic tracks when I desire to move vias by small increments.  Magnetic tracks are on by default.  Original 
      via complaint here: 
      http://tech.groups.yahoo.com/group/kicad-devel/message/1155
      
      Also mostly gotten rid of the annoying "Unable to drag this segment: two collinear segments" error.  Now, if two 
      (or more) segments are collinear, they are merged into one equivalent segment when you try to drag them while 
      maintaining slope.  I can't imagine any cases where this would be a bad thing (and I have plenty of experience where 
      the error was not desired!).  Note I say *mostly* because there still seem to be some length=1 (e.g. 0.003mm) segments 
      at the end of valid-length segments.  I do not want to remove them because this would change the board layout, though 
      in a basically imperceptible way.  We could maybe have an option to clean & remove these minimal-length segments, but 
      I worry that they serve to connect things slightly off grid & those things on-grid; also, removal may cause DRC 
      errors. It would be good if we could avoid their creation.(?)
      
      
      0dc3be88
    • dickelbeck's avatar
      layer names in *.brd file · 35b7973b
      dickelbeck authored
      35b7973b
    • dickelbeck's avatar
      layer names in *.brd file · 10e13ae5
      dickelbeck authored
      10e13ae5
  2. 03 Mar, 2008 1 commit
  3. 02 Mar, 2008 3 commits
  4. 01 Mar, 2008 2 commits
  5. 29 Feb, 2008 7 commits
  6. 28 Feb, 2008 5 commits
  7. 27 Feb, 2008 3 commits
  8. 26 Feb, 2008 5 commits
  9. 23 Feb, 2008 7 commits
  10. 22 Feb, 2008 2 commits