demos installation added in CMakeLists.
Temporary problem with help appeared.

docs->doc and help->doc/help relocation. DO NOT UPDATE YOU WORKING COPY UNTIL MY NOTEsvn st! Huge files will be relocated.

added an option to enable/disable magnetic tracks in the general options dialog of PCBnew (same as the magnetic 
pads option.)  Haven't fixed the via issue 
(since I don't quite understand why it is doing this, nor does it occur in 100% of the cases), but now you can just 
turn 
off magnetic tracks when I desire to move vias by small increments.  Magnetic tracks are on by default.  Original 
via complaint here: 
http://tech.groups.yahoo.com/group/kicad-devel/message/1155

Also mostly gotten rid of the annoying "Unable to drag this segment: two collinear segments" error.  Now, if two 
(or more) segments are collinear, they are merged into one equivalent segment when you try to drag them while 
maintaining slope.  I can't imagine any cases where this would be a bad thing (and I have plenty of experience where 
the error was not desired!).  Note I say *mostly* because there still seem to be some length=1 (e.g. 0.003mm) segments 
at the end of valid-length segments.  I do not want to remove them because this would change the board layout, though 
in a basically imperceptible way.  We could maybe have an option to clean & remove these minimal-length segments, but 
I worry that they serve to connect things slightly off grid & those things on-grid; also, removal may cause DRC 
errors. It would be good if we could avoid their creation.(?)

to PathHumanReadable().