added an option to enable/disable magnetic tracks in the general options dialog of PCBnew (same as the magnetic 
pads option.)  Haven't fixed the via issue 
(since I don't quite understand why it is doing this, nor does it occur in 100% of the cases), but now you can just 
turn 
off magnetic tracks when I desire to move vias by small increments.  Magnetic tracks are on by default.  Original 
via complaint here: 
http://tech.groups.yahoo.com/group/kicad-devel/message/1155

Also mostly gotten rid of the annoying "Unable to drag this segment: two collinear segments" error.  Now, if two 
(or more) segments are collinear, they are merged into one equivalent segment when you try to drag them while 
maintaining slope.  I can't imagine any cases where this would be a bad thing (and I have plenty of experience where 
the error was not desired!).  Note I say *mostly* because there still seem to be some length=1 (e.g. 0.003mm) segments 
at the end of valid-length segments.  I do not want to remove them because this would change the board layout, though 
in a basically imperceptible way.  We could maybe have an option to clean & remove these minimal-length segments, but 
I worry that they serve to connect things slightly off grid & those things on-grid; also, removal may cause DRC 
errors. It would be good if we could avoid their creation.(?)

================================================================================
+eeschema
        * commiting my changes to allow multiple instances of a given schematic file within 
a hierarchy:
        ** internally, m_currentScreen has been replaced with m_currentSheet,
                which is a list or 'path' of screens.  The path of screens is used to 
generate
                a series of timestamps, which is converted to flat component reference via 
a look-up
                table in the schematic files.
        ** this means that m_currentScreen is no longer used -- use GetScreen().
        ** GetScreen is virtual, as some of the dialogs keep around a WinEDA_BaseScreen 
pointer.
        ** all sub-sheets in a given schematic must have different names to generate a 
meaningful netlist.