updated tooltip

src/autocampars.php

@@ -3278,7 +3278,7 @@ DEFAULT_CONFIG
      <TRIG_CONDITION>"FPGA trigger sequencer trigger condition, 0 - internal, else dibits: 00 - do not use, 01 - keep, 10 - active low, 11 - active high for each GPIO[9:0] pin). 10389 board inverts signals, so 0x80000 - input from external connector,  0x08000 - input from internal flex cable (as in Eyesis). "</TRIG_CONDITION>
      <TRIG_DELAY>"FPGA trigger sequencer trigger delay, 32 bits in pixel clocks"</TRIG_DELAY>
      <TRIG_OUT>"FPGA trigger sequencer trigger output to GPIO, dibits: 00 - do not use, 01 - keep, 10 - active low GPIO output, 11 - active high GPIO output. 10389 board inverts signals, so 0x02000 - output to external connector (active high), 0x20000 - output to internal flex connector"</TRIG_OUT>
-     <TRIG_PERIOD>"FPGA trigger sequencer output sync period (32 bits, in pixel clocks). 0- stop. 1 - single, >=256 repetitive with specified period"</TRIG_PERIOD>
+     <TRIG_PERIOD>"FPGA trigger sequencer output sync period (32 bits, in 100MHz (10ns) clocks). 0- stop. 1 - single, >=256 repetitive with specified period"</TRIG_PERIOD>
      <TRIG_BITLENGTH>"Bit length minus 1 (in pixel clock cycles) when transmitting/receiving timestamps, without timestamps the output pulse width is 8*(TRIG_BITLENGTH+1). Legal values 2..255."</TRIG_BITLENGTH>
      <EXTERN_TIMESTAMP>"When 1 camera will use external timestamp (received over inter-camera synchronization cable) if it is available (no action when external syncronization is not connected), when 0 - local timestamp will be used"</EXTERN_TIMESTAMP>
      <XMIT_TIMESTAMP>"Specify output signal sent through internal/external connector (defined by TRIG_OUT). 0 - transmit just sync pulse (8*(TRIG_BITLENGTH+1) pixel clock periods long), 1 - pulse+timestamp 64*(TRIG_BITLENGTH+1) pixel clock periods long"</XMIT_TIMESTAMP>