system_defines.vh 3.74 KB
Newer Older
1 2 3
  // This file may be used to define same pre-processor macros to be included into each parsed file
`ifndef SYSTEM_DEFINES
  `define SYSTEM_DEFINES
Andrey Filippov's avatar
Andrey Filippov committed
4
  `define USE_DRP
5
  `define ALIGN_CLOCKS
Andrey Filippov's avatar
Andrey Filippov committed
6
  `define STRAIGHT_XCLK
7
  `define USE_DATASCOPE
8
//  `define DATASCOPE_INCOMING_RAW
9
  `define PRELOAD_BRAMS
10
//  `define AHCI_SATA 1
11
  `define DEBUG_ELASTIC  
12 13 14 15
// Enviroment-dependent options
  `ifdef IVERILOG
    `define SIMULATION
    `define OPEN_SOURCE_ONLY
16
    `define CHECKERS_ENABLED 1    
17 18 19 20
  `else
    `ifdef CVC
      `define SIMULATION
      `define OPEN_SOURCE_ONLY
21 22 23
      `define CHECKERS_ENABLED 1    
    `else
       `undef OPEN_SOURCE_ONLY
24
    `endif // CVC
25
    
26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142
  `endif // IVERILOG
  
// will not use simultaneous reset in shift registers, just and input data with ~rst  
 `define SHREG_SEQUENTIAL_RESET 1
// synthesis does to recognize global clock as G input of the primitive latch 
 `undef INFER_LATCHES
 // define when using CDC - it does not support them
 `undef IGNORE_ATTR
//`define MEMBRIDGE_DEBUG_READ 1
  `define use200Mhz 1
  `define USE_CMD_ENCOD_TILED_32_RD 1  
  // It can be used to check different `ifdef branches
  //`define XIL_TIMING //Simprim 
  `define den4096Mb 1
//  `define IVERILOG
  // defines for memory channels
  // chn 0 is read from memory and write to memory
 `define def_enable_mem_chn0
 `define def_read_mem_chn0
 `define def_write_mem_chn0
 `undef  def_scanline_chn0
 `undef  def_tiled_chn0
 
  // chn 1 is scanline r+w
 `define  def_enable_mem_chn1
 `define  def_read_mem_chn1
 `define  def_write_mem_chn1
 `define  def_scanline_chn1
 `undef   def_tiled_chn1

  // chn 2 is tiled r+w
 `define  def_enable_mem_chn2
 `define  def_read_mem_chn2
 `define  def_write_mem_chn2
 `undef   def_scanline_chn2
 `define  def_tiled_chn2

  // chn 3 is scanline r+w (reuse later)
 `define  def_enable_mem_chn3
 `define  def_read_mem_chn3
 `define  def_write_mem_chn3
 `define  def_scanline_chn3
 `undef   def_tiled_chn3

  // chn 4 is tiled r+w (reuse later)
 `define  def_enable_mem_chn4
 `define  def_read_mem_chn4
 `define  def_write_mem_chn4
 `undef   def_scanline_chn4
 `define  def_tiled_chn4

  // chn 5 is disabled
 `undef def_enable_mem_chn5

  // chn 6 is disabled
 `undef  def_enable_mem_chn6
 
  // chn 7 is disabled
 `undef  def_enable_mem_chn7
 
  // chn 8 is scanline w (sensor channel 0)
 `define  def_enable_mem_chn8
 `undef   def_read_mem_chn8
 `define  def_write_mem_chn8
 `define  def_scanline_chn8
 `undef   def_tiled_chn8

  // chn 9 is scanline w (sensor channel 1)
 `define  def_enable_mem_chn9
 `undef   def_read_mem_chn9
 `define  def_write_mem_chn9
 `define  def_scanline_chn9
 `undef   def_tiled_chn9

  // chn 10 is scanline w (sensor channel 2)
 `define  def_enable_mem_chn10
 `undef   def_read_mem_chn10
 `define  def_write_mem_chn10
 `define  def_scanline_chn10
 `undef   def_tiled_chn10

  // chn 11 is scanline w (sensor channel 3)
 `define  def_enable_mem_chn11
 `undef   def_read_mem_chn11
 `define  def_write_mem_chn11
 `define  def_scanline_chn11
 `undef   def_tiled_chn11

  // chn 12 is tiled read (compressor channel 0)
 `define  def_enable_mem_chn12
 `define  def_read_mem_chn12
 `undef   def_write_mem_chn12
 `undef   def_scanline_chn12
 `define  def_tiled_chn12
 
  // chn 12 is tiled read (compressor channel 1)
 `define  def_enable_mem_chn13
 `define  def_read_mem_chn13
 `undef   def_write_mem_chn13
 `undef   def_scanline_chn13
 `define  def_tiled_chn13
 
  // chn 12 is tiled read (compressor channel 2)
 `define  def_enable_mem_chn14
 `define  def_read_mem_chn14
 `undef   def_write_mem_chn14
 `undef   def_scanline_chn14
 `define  def_tiled_chn14
 
  // chn 12 is tiled read (compressor channel 3)
 `define  def_enable_mem_chn15
 `define  def_read_mem_chn15
 `undef   def_write_mem_chn15
 `undef   def_scanline_chn15
 `define  def_tiled_chn15
`endif