notes with new simulation commands/comments gor gpio and command sequencer

jpeg_sim_multi 8

jpeg_sim_multi 8

jpeg_sim_multi 8

jpeg_sim_multi 8

################## Simulate Parallel ####################

./py393/test_mcntrl.py @py393/cocoargs  --simulated=localhost:7777

measure_all "*DI"

setup_all_sensors True None 0xf

set_sensor_io_ctl  all None None 1 # Set ARO low - check if it is still needed?

#just testing

set_gpio_ports  1 # enable software gpio pins - just for testing. Also needed for legacy i2c!

set_gpio_pins 0 1 # pin 0 low, pin 1 - high

#sequencer test

#ctrl_cmd_frame_sequencer  <num_sensor>  <reset=False>  <start=False>  <stop=False>

ctrl_cmd_frame_sequencer   0  0  1  0

write_cmd_frame_sequencer  0  1  1  0x700  0x6

write_cmd_frame_sequencer  0  0  3  0x700  0xa000

write_cmd_frame_sequencer  0  1  0  0x700  0x90

write_cmd_frame_sequencer  0  0  2  0x700  0xe00

write_cmd_frame_sequencer  0  0  3  0x700  0xa

#set_sensor_io_dly_hispi all 0x48 0x68 0x68 0x68 0x68

#set_sensor_io_ctl all None None None None None 1 None # load all delays?

compressor_control  all  None  None  None None None  2

compressor_interrupt_control all clr

compressor_interrupt_control all en

compressor_control  all  3

jpeg_sim_multi 4

jpeg_sim_multi 8

jpeg_sim_multi 8

ctrl_cmd_frame_sequencer  0  0  1 0

ctrl_cmd_frame_sequencer  <num_sensor>  <reset=False>  <start=False>  <stop=False>

#set_gpio_ports  <port_soft=None>  <port_a=None>  <port_b=None>  <port_c=None>

set_gpio_ports  1 # enable software gpio pins - just for testing. Also needed for legacy i2c!

set_sensor_io_ctl  <num_sensor>  <mrst=None>  <arst=None>  <aro=None>  <mmcm_rst=None>  <clk_sel=None>  <set_delays=False>  <quadrants=None>

wait_irq 0xf0 100000

wait_irq 0xf0 100000

wait_irq 0x0    100

wait_irq 0x0    100