system_defines.vh 3.96 KB
Newer Older
1 2 3
  // This file may be used to define same pre-processor macros to be included into each parsed file
`ifndef SYSTEM_DEFINES
  `define SYSTEM_DEFINES
4
  `define PRELOAD_BRAMS
5
  `define DISPLAY_COMPRESSED_DATA  
6
  // if HISPI is not defined, parallel sensor interface is used for all channels
7
  `define HISPI
8
//    `define USE_OLD_XDCT393  
9 10 11
//  `define USE_PCLK2X
//  `define USE_XCLK2X
//  `define DEBUG_RING 1
12 13 14 15 16 17
//  `define MCLK_VCO_MULT 16
// DDR3 memory speed grade and density
    `define sg25 1
//  `define sg15E  1
//  `define sg187E  1
  `define den4096Mb 1  
18
  
19 20 21 22
  `define MCLK_VCO_MULT 16
//  `define MCLK_VCO_MULT 18
//  `define MCLK_VCO_MULT 20
    
23
  `define MEMBRIDGE_DEBUG_WRITE 1
24 25 26 27 28 29 30 31 32 33 34
// Enviroment-dependent options
  `ifdef IVERILOG
    `define SIMULATION
    `define OPEN_SOURCE_ONLY
  `else
    `ifdef CVC
      `define SIMULATION
      `define OPEN_SOURCE_ONLY
    `endif // CVC
  `endif // IVERILOG
  
35 36
// will not use simultaneous reset in shift registers, just and input data with ~rst  
 `define SHREG_SEQUENTIAL_RESET 1
37 38
// synthesis does to recognize global clock as G input of the primitive latch 
 `undef INFER_LATCHES
39 40
 // define when using CDC - it does not support them
 `undef IGNORE_ATTR
41
//`define MEMBRIDGE_DEBUG_READ 1
42
  `define use200Mhz 1
43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92
  `define USE_CMD_ENCOD_TILED_32_RD 1  
  // It can be used to check different `ifdef branches
  //`define XIL_TIMING //Simprim 
  `define den4096Mb 1
//  `define IVERILOG
  // defines for memory channels
  // chn 0 is read from memory and write to memory
 `define def_enable_mem_chn0
 `define def_read_mem_chn0
 `define def_write_mem_chn0
 `undef  def_scanline_chn0
 `undef  def_tiled_chn0
 
  // chn 1 is scanline r+w
 `define  def_enable_mem_chn1
 `define  def_read_mem_chn1
 `define  def_write_mem_chn1
 `define  def_scanline_chn1
 `undef   def_tiled_chn1

  // chn 2 is tiled r+w
 `define  def_enable_mem_chn2
 `define  def_read_mem_chn2
 `define  def_write_mem_chn2
 `undef   def_scanline_chn2
 `define  def_tiled_chn2

  // chn 3 is scanline r+w (reuse later)
 `define  def_enable_mem_chn3
 `define  def_read_mem_chn3
 `define  def_write_mem_chn3
 `define  def_scanline_chn3
 `undef   def_tiled_chn3

  // chn 4 is tiled r+w (reuse later)
 `define  def_enable_mem_chn4
 `define  def_read_mem_chn4
 `define  def_write_mem_chn4
 `undef   def_scanline_chn4
 `define  def_tiled_chn4

  // chn 5 is disabled
 `undef def_enable_mem_chn5

  // chn 6 is disabled
 `undef  def_enable_mem_chn6
 
  // chn 7 is disabled
 `undef  def_enable_mem_chn7
 
93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126
  // chn 8 is scanline w (sensor channel 0)
 `define  def_enable_mem_chn8
 `undef   def_read_mem_chn8
 `define  def_write_mem_chn8
 `define  def_scanline_chn8
 `undef   def_tiled_chn8

  // chn 9 is scanline w (sensor channel 1)
 `define  def_enable_mem_chn9
 `undef   def_read_mem_chn9
 `define  def_write_mem_chn9
 `define  def_scanline_chn9
 `undef   def_tiled_chn9

  // chn 10 is scanline w (sensor channel 2)
 `define  def_enable_mem_chn10
 `undef   def_read_mem_chn10
 `define  def_write_mem_chn10
 `define  def_scanline_chn10
 `undef   def_tiled_chn10

  // chn 11 is scanline w (sensor channel 3)
 `define  def_enable_mem_chn11
 `undef   def_read_mem_chn11
 `define  def_write_mem_chn11
 `define  def_scanline_chn11
 `undef   def_tiled_chn11

  // chn 12 is tiled read (compressor channel 0)
 `define  def_enable_mem_chn12
 `define  def_read_mem_chn12
 `undef   def_write_mem_chn12
 `undef   def_scanline_chn12
 `define  def_tiled_chn12
127
 
128 129 130 131 132 133
  // chn 12 is tiled read (compressor channel 1)
 `define  def_enable_mem_chn13
 `define  def_read_mem_chn13
 `undef   def_write_mem_chn13
 `undef   def_scanline_chn13
 `define  def_tiled_chn13
134
 
135 136 137 138 139 140
  // chn 12 is tiled read (compressor channel 2)
 `define  def_enable_mem_chn14
 `define  def_read_mem_chn14
 `undef   def_write_mem_chn14
 `undef   def_scanline_chn14
 `define  def_tiled_chn14
141
 
142 143 144 145 146 147
  // chn 12 is tiled read (compressor channel 3)
 `define  def_enable_mem_chn15
 `define  def_read_mem_chn15
 `undef   def_write_mem_chn15
 `undef   def_scanline_chn15
 `define  def_tiled_chn15
148 149
`endif